fixing a 4speed ratchet top tranny

on the floor, hard to believe but proves this modification is working. See picture to show you basic fit talence defoncage de fion where the o ring is located on the gear. Install with parts facing other ways. Here it is as I received the tranny,1965 OEM tranny that came with my early FL66 project. After witnessing the bike the trans came out of while researching another article, we would be completely surprised if this was a "fresh box." And not to disappoint you, it wasn't fresh, but it wasn't bad, either. As you can see now everything should come out. Replica 4-speed transmission with rotary top and mount lugs to accept aluminum inner primary covers. To install the seal, slide the driver (arrow) over the sleeve and tap new seal into place in the end of fourth gear. See gear mounted vertically with nothing more than friction of the 2 seals and close tolerance getting the gear quite tight on fixing a 4speed ratchet top tranny the shaft, but still turn freely on the shaft no problems. These old Harley trannys are almost indestructible but have a problem they often leak to the ground. New shifter dog were use with new shifter fork, you can also see assembly lube. I re-use the oem kicker start gear until I find a better one, even if teeth were slightly worn. The stud mounting holes are drilled through into the inside of the case (arrow the factory originally used an interference fit style of threads that sealed themselves as they were installed. So there is not enough material, meaning the bushing is not supporting on the shaft properly. Took off the bearing lock plate.
  • » Classic Harley ratchet top transmission, complete tear
  • Classic Harley ratchet top transmission, complete tear down and total rebuild. Kicker cover, ratchet top and tranny has been blast, clean,re clean, re-cleanthen paint with VHT cast aluminum high heat. Install the tool on the ratchet top adjust with straight slot then lock in place. Ratchet, lid Rebuild Okay this nasty broke-up ratchet top lid has.
  • Scrape out gasket off the top of the transmission case. Free up the forks, too. Find neutral on the drum which should look like this. Shovelhead 4 Speed Saga Part.
  • This burr, no matter how slight, will prevent the gasket from being compressed thus allowing oil to pass by the gasket. The first problem I have found is that the bushing is often too loose on the main shaft.

fixing a 4speed ratchet top tranny
Will fixing a 4speed ratchet top tranny accept belt or chain final rear drive which accepts elec. T drained the oil from the gearbox while the transmission was in the frame, now would be a good time. Next take off the complete cluster assembly.
fixing a 4speed ratchet top tranny

Vidéos

Storm Lattimore in 10 Mins til Checkout.